Icom IFC-30LT Manual page 16

For example, we will add a CTCSS code of 151.4 (for transmission and reception) on
channel 8 (TX = RX Frequ = 152.540 MHz, see above)
SEQUENCE
1 TRANSCEIVER OFF
2 PRESS SIMULTANEOUSLY ON
PTT
TRANSCEIVER ON
3 KEY IN ACCESS CODE (
CONFIRM BY PRESSING
4 PRESS SIMULTANEOUSLY ON
PROGRAMMING PER CHANNEL
AT THIS POINT YOU CAN PROGRAM THE CHANNEL IN A « BANK ». THERE ARE 6
« BANKS » OF 16 CHANNELS EACH.
THE SELECTION OF A « BANK » IS DONE BY PRESSING
IF YOU WANT TO SAVE YOUR FREQUENCY ON CHANNEL 5 OF « BANK » 2, YOU
WILL HAVE TO SELECT « BANK » 2 USING
DISPLAYED IN THE TOP LEFT CORNER.
NOTE FOR USING CHANNELS STORED IN BANKS you will have to select the correct
P 1 (
bank by pressing
channel 5 to transmit and receive on this channel.
IF YOU WANT TO SAVE YOUR FREQUENCY ON « BANK » 1, THE SELECTION OF THE
BANK WILL STILL HAPPEN USING
BUTTON UNTIL NO FIGURE APPEARS ON THE TOP PART OF THE DISPLAY
INDICATING YOU ARE IN
Guideline Télécom MSFB
ACTION
Po
AND AND TURN
159357
2
AND
ONTHE KEYPAD TO ACCESS THE
« bank » 2 in our example) and then rotate the channel selector to
P 1
BUT YOU WILL HAVE TO PRESS THIS
« BANK » 1.
Technical Sheets
OR ) AND
258456
P 1
P 1
AND CHECK THAT FIGURE 2 IS
ICOM IC-F30 LT
DISPLAY
- - - - - - -
SET MODE
CH 01
16
05/08/2002