Zamel Cet LediX SLR-11P Manual

RGB Control kit
SLR-11P
Mounting
Mounting
in a Ø60 indoor
only
junction box
The SLR-11P kit consists of a wireless SLR-11 controller and P-260 touch remote control. The kit is de-
signed to cooperate with RGB products such as RGB LEDIX series standard lighting fittings and 10÷14 V
DC RGB strips and modules. When connected with RGB products it enables to set the lighting colour in
a fluent way by means of a touch remote control P-260 and to change the luminous flux intensity of a
chosen lighting colour. Additionally, SLR-11P realizes the automatic (fluent/strobe way) colour change
with a possibility of storing the programme with the chosen colour in the controller's memory. It is also
possible to adjust the white colour temperature by means of a touch pad. The remote control included
in the kit is added to SLR-11 controller by means of default settings. After mounting the kit, it is ready to
use. The possibility of adding different P-260 controllers and chosen EXTA FREE system transmitters is an
additional advantage of the set. In this way the users are not limited to only one transmitter as it usually
happens in the competitive solutions. The small controller's dimensions allow for its easy mounting in
a Ø60 junction box.
Functions:
• switching on / switching off,
• white colour temperature adjustment,
• lighting colour fluent choice by means of a touch pad (RAINBOW),
• floating (FLOATING) and strobe (STROBE) functions,
• automatic colour change with time adjustment,
• luminous flux intensity change (brightening / dimming).
Colour table defined in the controller (STROBE mode)
CAUTION
• While connecting the RGB products to SLR-11 controller, the maximum output load should not be
exceeded. If there is a need to increase the controller's output load, then an additional RGB amplifier
circuit should be used (WLN-01 or WLP-01).
Detailed mounting and programming instruction is inside the packaging.
P-260 SLR-11
4,5 V (3 x AAA); IP20 10÷14 V DC / 0,22 W; IP20
weight: 27 g
weight: 100 g
CET Lighting Sp. z o.o. declares that the device complies with
the essential requirements and other relevant provisions of
the RTTE Directive.
The symbol means selective collecting
of electrical and electronic equipment.
It is forbidden to put the used
equipment together with other waste.
Declaration of Conformity is on www.ledix.pl
SCAN
the technical
data
Cet Lighting Sp. z o.o.
43-200 Pszczyna, ul. Zielona 27
tel: +48 32 449 15 00, fax: +48 32 449 15 02
e-mail: ledix@ledix.pl, www.ledix.pl
1471
RGB Control kit
TYPE: SLR-11P
SLR-11P GB Ver. 01
RGB Control kit
SLR-11P
10 ÷ 14 V DC