Reach; Troubleshooting - Stihl RM 2.0 R Instruction Manual

RM 2.0 RC
Displacement 149 ccm
Fuel tank 1,4 l
Speed of cutting
device 2800 rpm
In accordance with
Directive
2000/14/EC:
Guaranteed sound
power level L 93 dB(A)
WAd
In accordance with
Directive
2006/42/EC:
Sound pressure level
at workplace L 79 dB(A)
pA
Uncertainty K 2 dB(A)
pA
Specified vibration
characteristic in
accordance with
EN 12096:
Measured value a 4,40 m/s
hw
Uncertainty K 2,20 m/s
hw
Measurement in
accordance with
EN 20643
L/W/H 124/29/100 cm
Weight: 27 kg
RM 2.0 RT
Engine type Kohler HD675
Nominal output at 2,2 - 2800
nominal speed kW - rpm
Displacement 149 ccm
Fuel tank 1,4 l
Speed of cutting
device 2800 rpm
In accordance with
Directive
2000/14/EC:
Guaranteed sound
power level L 93 dB(A)
WAd
44
RM 2.0 RT
In accordance with
Directive
2006/42/EC:
Sound pressure level
at workplace L
Uncertainty K
Specified vibration
characteristic in
accordance with
EN 12096:
Measured value a
Uncertainty K
Measurement in
accordance with
EN 20643
Drive: Front wheel
Drive speed
L/W/H
Weight:
2
2

18.1 REACH

REACH is an EC Directive for the
registration, evaluation, authorisation and
restriction of chemicals.
Information on compliance with the
REACH Directive (EC) No. 1907/2006 is
available from www.stihl.com/reach.

19. Troubleshooting

If necessary, contact a specialist
dealer; STIHL recommends STIHL
specialist dealers.
@ See engine instruction manual.
79 dB(A)
pA
2 dB(A)
pA
2
4,40 m/s
hw
2
2,20 m/s
hw
1 forward gear
3,5 km/h
140/50/105 cm
30 kg
Fault:
Engine not starting
Possible cause:
– Motorstop lever not pressed.
– No fuel in tank.
– Fuel line blocked.
– Inferior, dirty or old fuel in tank.
– Air filter dirty.
– Spark plug socket detached from spark
plug; ignition lead not properly fastened
to socket.
– Spark plug dirty or damaged; incorrect
electrode gap.
Remedy:
– Press motorstop lever to handlebar and
hold. ( 11.1)
– Refill fuel tank. ( 7.3)
– Clean fuel line. ,
– Always use fresh, good quality fuel,
unleaded petrol; clean
carburettor. ,
– Clean air filter. ,
– Connect spark plug socket; check
connection between ignition lead and
socket. ,
– Clean or replace spark plug; adjust
electrode gap.
Fault:
Starting problems or deteriorating engine
power.
Possible cause:
– Lawn mower housing blocked.
– Mowing at an excessively low cutting
height or propulsion speed is too high in
relation to the cutting height.
– Water in fuel tank and carburettor;
carburettor blocked.
– Fuel tank contaminated.
– Air filter dirty.
0478 111 9944 B - EN