FusionModule1000A40 Prefabricated All-in-One
Data Center
Maintenance Guide
Step 2 Remove the inner cover.
Figure 5-24 Removing the inner cover
Step 3 Use a Phillips screwdriver to remove the screws that fasten the camera to its base.
Figure 5-25 Removing the camera base
Step 4 Remove the network cable and take out the camera.
Step 5 Install the new camera by following instructions in documents delivered with the
camera, tighten the screws to secure the camera to the base, and reconnect the
network cable in the original way.
Step 6 Adjust the angle of the camera to cover the monitored area by following
instructions in documents delivered with the camera.
Step 7 Configure the camera by referring to the management system initial configuration
table.
Issue 04 (2021-02-10)
NO TE
In the scenario with an SD card, remove the SD card and install it in a new camera.
Copyright © Huawei Technologies Co., Ltd.
5 Parts Replacement
82