Kenwood TK-5210 Service Manual page 54

Item Condition
10.DTMF 1) Adj item:[W DTMF Dev]
deviation Adjust:[***]
adjust Deviation meter filter
•Wide LPF:15kHz
(Concentric SW:A) HPF:OFF
PTT:ON
Press [B] to store the adjustment
value after adjustment.
•Narrow 2) Adj item:[N DTMF Dev]
(Concentric SW:B, C) Adjust:[***]
PTT:ON
Press [B] to store the adjustment
value after adjustment.
11.Single tone 1) Adj item:[W Tone Dev]
deviation Adjust:[***]
adjust Deviation meter filter
•Wide LPF:15kHz
(Concentric SW:A) HPF:OFF
PTT:ON
Press [B] to store the adjustment
value after adjustment.
•Narrow 2) Adj item:[N Tone Dev]
(Concentric SW:B, C) Adjust:[***]
PTT:ON
Press [B] to store the adjustment
value after adjustment.
12.MSK 1) Adj item:[W MSK Dev]
deviation Adjust:[***]
adjust Deviation meter filter
•Wide LPF:15kHz
(Concentric SW:A) HPF:OFF
PTT:ON
Press [B] to store the adjustment
value after adjustment.
•Narrow 2) Adj item:[N MSK Dev]
(Concentric SW:B, C) Adjust:[***]
PTT:ON
Press [B] to store the adjustment
value after adjustment.
13.BATT 1) Adj item:[Battery]
TX inhibit Adjust:[***]
voltage PTT:ON
adjust
14.BATT [Panel test mode]
TX inhibit 1) CH-Sig:1-1
voltage BATT terminal voltage:6.0V
Check PTT:ON
BATT terminal voltage:5.8V
PTT:ON
ADJUSTMENT
Measurement
Test-
Unit Terminal
equipment
Power meter Panel ANT
Deviation Universal
meter connector
Oscilloscope
AG
AF VTVM
Power meter Panel ANT
DVM BATT
terminal
Adjustment
Unit Parts Method
Panel [C],[D] 3.0kHz
1.5kHz
3.0kHz
1.5kHz
3.0kHz
1.5kHz
Panel After pressing the BATT terminal voltage:5.8V
PTT switch, confirm
that one predetermined
numeric in the range
1 to 256 appears and
then press [B] key.
That numeric will be
stored in memory.
Check
TK-5210
Specifications/Remarks
±50Hz
±50Hz
±50Hz
±50Hz
±50Hz
±50Hz
The transceiver can
transmit and the red
LED blinking.
The transceiver cannot
transmit.
53