Table of Contents
Advertisement
Repair
615
616
F
. 37
IG
9. Install cover plates including the outer blue cover
(520), two side blue covers (605) and top blue cover
(606) with twelve M3 BHCS screws (514) torqued to
12 in-lb (1.35 N•m).
10. Apply a thin coat of lithium grease to the 1/2 in.
BSPP washer seal (603) and threads of the
customer supplied inlet fitting. Thread into the SST
single inlet adapter (602) and torque to Torque to 15
ft-lb (20.34 N•m).
26
605
614
Customer
supplied
inlet fitting
F
. 38
IG
Nozzle Group Assembly
1. Install adapter gasket (102) into the end of the 3D
NOTE: The open end of the valve shut off bearing (104)
must towards the dispensing nozzles.
2. Apply anti seize lubricant to the threads of the 3D
3. Rest the turnbuckle locking nut (101) on the
NOTE: Refer to Nozzle Head and Material Tube
Assembly on page 29 to determine which 3 head
adapter assembly goes with which model number.
4. Insert the dowel pins of the 3 head adapter
519
603
520
long tube assembly (103). Install valve shut off
bearing (104) onto the ball shut off needles (418).
long tube assembly (103) and the 3 head adapter
assembly (105).
threaded end of the long 3D tube assembly (503)
but do not thread on.
assembly (105) into the long 3D tube assembly
(103). Turn the turnbuckle nut clockwise as seen
facing the swivel housing so that the threads of the
long 3D tube assembly (103) and the 3 head
adapter assembly (105) Torque the nut to 75 ft-lb
(101.69 N•m). See F
. 39.
IG
606
602
605
3A8476A
Advertisement
Table of Contents
