Using For The First Time; Making An Espresso - Krups XP52 Series Manual

5. USING FOR THE FIRST TIME

Before using your espresso machine, clean all the accessories in soapy water and dry them.
If you are not using the Claris cartridge, please refer to the paragraph here below "RINSING OF YOUR
APPLIANCE".
CLARIS CARTRIDGE SET-UP:
If you are using a Claris filter cartridge, please follow the procedure to fill it with water:
Screw the Claris filter into the bottom of the water tank.
Fill the water tank with water and replace it (fig.2 and 3).
Turn the appliance on by pressing the "On / Off" button (fig.4).
Turn the switch to the "steam preheating" position. Once the light stops blinking, turn back the switch
to the "off" position.
Repeat this operation 2 more times.
To make sure the Claris cartridge is full of water, place a container under the brewing head, turn the switch
to the "coffee" position and make sure some water is running through. If not, repeat the above procedure.
RINSING OF YOUR APPLIANCE:
Then rinse the appliance. To do so:
Open the lid and remove the water tank using the handle (fig.1).
Fill it with water (fig. 2).
Replace the water tank by positioning it firmly, to ensure the water inlet is in place, and close the lid
(fig.3).
Turn the appliance on by pressing the "On / Off" button (fig.4).
Insert the filter holder (without ground coffee) in the appliance (fig.7).
Place a container of sufficient volume under the filter holder.
Once the appliance has reached the right temperature, the light stops blinking. Turn the switch to the
"coffee" position (fig.8) and let all the water in the tank run through.
If necessary, stop the operation by turning the switch to the "off" position (fig.9) to empty the container
and then resume the operation.
Empty the container and unlock the filter holder: press the "OPEN" button on the filter holder and turn
it to the left (fig.10).

6. MAKING AN ESPRESSO

In order to release all the aromas of the coffee and ensure your complete satisfaction, this machine pre-
infuses each coffee. The pump works for 3 seconds, stops the following 3 seconds and then the cycle
continues until the end of the preparation.
PREHEATING THE ACCESSORIES
For the best results, we recommend that you preheat the accessories (filter holder and cups) without
espresso ground coffee. To do so:
Fill the water tank and turn the machine on. (fig.1, 2, 3 and 4).
Put the filter holder in place, place the cups below.
As soon as the appliance reaches the required temperature, the light stops flashing.
Turn the switch to the "coffee" position (fig.8).
When the cups are filled with hot water, turn the switch to the "off" position. (fig.9).
English
53