Advertisement
Wall Mount Installation -
(E)H(M)(T)V, FD9368-HTV, FD9388-HTV
Below is a sample procedure using wall mount bracket and an FD8369A:
1. Determine a hard surface wall location, and use the four mounting holes on the bracket
to mark the positions where holes will be drilled to secure the bracket.
Aligned with C holes
2. Drill holes on the wall for securing the bracket and for routing cables.
3. Route cables through the wall and bracket.
4. Secure the wall mount bracket to the wall using the included screws and plastic
anchors.
5. You will need to pass cables through the waterproof connectors, and then use a
crimping tool to connect the cable wires to an RJ45 connector. See page 5.
6. Secure the camera to the bracket using the included screws.
7. Connect power lines and cables to the camera.
8. Proceed with initial setup such as enabling network access, focus tuning, or zooming.
When done, secure the outer dome cover.
FD8367A, FD8369A, FD8377-HV, FD8379-HV, FD9389-
7
Advertisement
