Related Manuals for Vivotek AM-105
Summary of Contents for Vivotek AM-105
- Page 1 VIVOTEK Fixed Dome Series AM-105 Recessed-mount Bracket Installation Guide Corresponding part number: 900026802G Rev. 1.2 IP Sur veillance...
-
Page 2: Revision History
FD816BA-HF2, FD816BA-HT, FD8182-F2, FD8182-T, FD9171-HT, FD9181-HT, FD9165-HT, FD9167-H, FD9167-HT, FD8177-HT, FD9187-H/-HT You may also refer to VIVOTEK's website for the list of supported models. Support for other models can be available through time. IMPORTANT: Before installing your camera, make sure the built-in PIR (Passive Infrared Sensor) can be directed toward the area of interest, where possible intrusion may occur. -
Page 3: Installation
Installation Mounting Hole Definitions 1. Determine a secure location for the recessed-mount bracket. 2. Drill or cut a 186mm hole (in diameter). The maximum thickness of the ceiling/board is 24mm. The ceiling board should be able to sustain at least a weight of 1.4kg. 186mm Up to 24mm... - Page 4 4. Use the included T10 stardriver to detach the dome cover from the recessed mount bracket. 5. Remove the breakaway tab from the bottom of the camera so that you can route cabIes through the opening.
- Page 5 6. Install camera to the recessed-mount bracket by driving 3 screws. M3 M4 Mount hole Applicable models Screws FD9165-HT, FD9167-H/HT, FD8177-HT, 3x round head M4X8L FD9187-H/-HT FD8182F2/T, FD9171-HT, FD9181-HT, 3x round head M3X8L FD816BA-HT/HF2 NOTE: 1. Connect and route cables before you secure the recessed-mount bracket to a ceiling. 2.
- Page 6 7. Pass cables through the routing hole and connect cables to the camera. 8. Use a #2 Phillips screwdriver to loosen the clamping plates (see drawing below) and insert the recessed-mount bracket through the hole in the ceiling.
- Page 7 9. Use a #2 Phillips screwdriver to move the clamping plates down so that the ceiling/ board is caught between the clamps and the flange on the other side of the ceiling. Clockwise Counter- clockwise 10. Adjust the shooting angle and check for a satisfactory image over a web session. When you have a satisifactory live view, tighten the tilt screw, and secure the dome cover from below the ceiling using the T10 stardriver.
- Page 8 11. You are done with the installation. IMPORTANT: The ceiling mount configuration does not support the Corridor view. If using the Corridor view, some part of the view area may not be properly revealed.