Related Manuals for Vivotek Speed Dome Series
Summary of Contents for Vivotek Speed Dome Series
- Page 1 VIVOTEK Speed Dome Series AM-103 Recessed-mount Bracket Installation Guide Corresponding part number: 900014000G Rev. 1.1 IP Sur veillance...
- Page 2 Speed Dome series SD8332E, SD8363E, SD8364E, SD83x4E, SD83x6E, SD8333E You may also refer to VIVOTEK's website for the list of supported models. Support for other models can be available through time. IMPORTANT: This recessed mount bracket is for indoor use only.
-
Page 3: Installation
Installation Mounting Hole Definitions 1. Determine a secure location for the recessed-mount bracket. 2. Drill or cut a 260mm hole (in diameter). The maximum thickness of the ceiling/board is 48mm. The ceiling should be able to sustain at least a weight of 6kgs. 260mm Up to 48mm... - Page 4 4. Remove the interface circuit board from the interface section. Loosen the two crosshead screws. AC24V DI GND AC24V Reserved MIC IN Line OUT Audio GND RS485- DO+(12V) RS485+ 5. Fasten the black M4 machine screws to secure the interface section of the camera to the recessed-mount bracket.
- Page 5 6. Attach the camera body to the interface section by aligning the indicator mark on the camera with that on the interface section. Turn the camera counter-clockwise until the indicator mark is aligned with the "C" mark. Note that the dome cap section of the camera is not used in this installation.
- Page 6 7. Turn the assembly over and place it carefully on the foam blocks that came with the shipping package to prevent damage to the dome cover. Secure the anti-tamper screws from the openings on the bracket using the included T25 stardriver. Optional: You can tie up one or more tether lines to the top or the sides of the bracket in case the bracket should fall during the installation...
- Page 7 8. Connect cables to the camera. Please refer to the Quick Installation Guide for connection pinouts. 9. Use a #2 Phillips screwdriver to loosen (turning clockwise) the clamping plates, and then insert the recessed-mount bracket through the pre-drilled hole in the ceiling.
- Page 8 10. Use a #2 Phillips screwdriver to move the clamping plates down so that the ceiling/ board is caught between the clamps and the flange on the other side of the ceiling. Clockwise Counter- clockwise 11. Align and attach cover ring to the bracket by turning it counter-clockwise.