Vivotek AM-21N Installation Manual

VIVOTEK Mounting Accessories
AM-21N Tilt Bracket
Installation Guide
Revison History:
Rev. 1.0: Initial release
I Compatible VIVOTEK Cameras
Compatible cameras/brackets
MS9390-HV
Mounting Dimensions
Attach the included alignment sticker to a preferred position.
A-2
Drill holes on the wall and install the tilt bracket. If the space
behind the wall allows, you may also pass cables through the
wall.
Ø 6.5mm
Attach the tether wire to the back of the camera.
A-4
Accessory Ordering part no.: 100228700G
Package Contents
M4 X 25
unit: mm
Remove the top cover from your camera.
A-3
x4
Torque: 6.5±0.5kgf-cm
Install the waterproof components of the cable gland to your
A-5
Ethernet cable following the QIG of your camera. The cable
gland will be placed within the protection of the tilt bracket.
Installation
II
There are 3 mount types:
A
A. Wall mount,
B
B. Pole mount via AM-312,
Corner mount via AM-412
C
C. to electrical junction box.
If using the side hole,
seal the center hole.
Attach the waterproof cable gland to the retention clips at the
A-6
back of the camera. Connect a grounding wire to the ground
screw of the camera.
Stainless SS M3*5
Green/Yellow
≥ 20AWG
802.3at
1.5m
7 5 3 1
ON
100~240V LAN/PoE
AC
OFF
8 6 4 2
Install the dome cover to the camera.
A-8
x4
Torque: 6.5±0.5kgf-cm
A Remove the plastic plug on the conduit hole. A 3/4" conduit is
required for routing the cables with waterproof connection.
A-1
Install the cable gland and pass cables through it. The conduit
is user-supplied.
Install the cable conduit before wall-mounting. The conduit
can be installed from the side or through the center hole.
OR
Install the camera to the tilt bracket by fastening 4 T10
A-7
screws.
T10
9 10
GE LAN GE LAN
Open a live view console and adjust the shooting direction.
Refer to the camera's QIG for more information.
3/4"