Advertisement
Wall Mount Installation -
FD8177-HT, FD9187-H(T)V
Below is a sample procedure using the wall mount bracket and an FD9171:
1. Determine a hard surface wall location, and use the four mounting holes on the wall
mount bracket to mark the positions where holes will be drilled to secure the bracket.
6
Aligned with B holes
2. Drill holes on the wall for passing cables and for securing the wall mount bracket.
3. Secure the bracket by hammering anchors into the wall and then fasten screws.
4. Route power lines and other cables through the bracket and wall.
5. Use a cutting plier to remove the plastic tab on the pre-cut routing hole.
6. Pass cables through hole.
7. Secure camera to the wall mount bracket using the B holes and M4x10 screws.
8. Proceed with initial setup such as enabling network access, focus tuning, or zooming.
When done, secure the outer dome cover.
FD9171-HT, FD9181-HT, FD9165-HT, FD9167-H(T),
5
7
6
Advertisement
