8010Co Chassis - Avaya 8800 Installation Manual

Chassis installation fundamentals
To install the 8010, 8006, or 8003-R chassis in an equipment rack, you need a Phillips
screwdriver and an equipment rack that meets the following specifications:
• Heavy-duty steel construction
• Electronic Industries Association (EIA) standard hole spacing
• Width of 19 in. (48.26 cm) and depth of 24 in. (60.96 cm)

8010co chassis

In addition to the 8010co chassis, your shipping container contains several hardware
accessories. Verify that the items in the shipping container match those on the shipment
packing list.
Use Figure 7: Items in the 8003-R chassis shipping container
when you verify the contents of the shipping container. For information about ordering
replacement parts, see
Table 4: 8010co chassis shipping accessories
Check
Antistatic wrist strap
One 10-ft console serial cable
Screws and hardware:
12 Phillips-head screws
12 clip nuts
4 Phillips-head screws
4 hex nuts
4 pan-head screws
Installation shelf
One upper cable management
bracket
Two side cable management
brackets
Figure 8: Accessories in the 8010co chassis shipping container
accessories in the 8010co chassis shipping container.
38 Installation — Chassis
Part numbers on page 81.
Accessory
Direct the discharge of static electricity from
your body to the chassis and avoid discharge to,
and possible damage of, sensitive electronic
components.
Connect an optional management console.
The hardware required to mount the chassis in
a rack depends on your rack type.
Mount the chassis to a rack rail.
Use the clip nuts if necessary.
The hardware required to mount the installation
shelf in a rack depends on your rack type.
Mount the installation shelf to a rack rail.
Mount the installation shelf to a rack rail.
Install the cable management bracket.
Mount the 8010co chassis in an equipment
rack.
Manage network interface cables.
Manage network interface cables.
Comments? infodev@avaya.com
on page 37 link and as a checklist
Usage
on page 39 illustrates the
November 2012