Rear-View Mirrors; Idle Adjustment - Gilera Runner 125 Manual

Rear-view mirrors (03_38, 03_39)

The mirrors can be set to the desired position by adjusting the mirror frame.
03_38
The mirrors must be adjusted so that the shafts are perpendicular to the vehicle's
direction axis.
To adjust the mirror angle, remove the rubber cap «A», loosen the screw «B» located
at the base of the stem and tighten it once the desired position is achieved.
03_39

Idle adjustment (03_40, 03_41, 03_42)

The idle speed is adjusted by means of the idle speed adjuster screw «A» located on
the carburettor.
To do this you must lift the seat, remove the access door on the bottom of the helmet
compartment, by unscrewing the fives screws «B». Idle adjustment must be carried
out with the rear wheel lifted off the ground (vehicle resting on centre stand) and with
a hot engine. Screw or unscrew the knob-type head screw until the engine idles
smoothly, i.e. without the rear wheel being moved by the engine.
To adjust the throttle transmission clearance it is necessary to intervene on the ad-
justment screw «C» located on the right side of the carburettor. Once this operation
03_40
is finished, refit the rubber cap protecting the adjustment screw.
58