First Time Installation - L&T Electrical & Automation 1 Phase DIN Rail Meter User Manual

STANDARDS APPLICABLE
 Radiated RF field immunity
 Conducted RF immunity
 Conducted RF emissions
 Radiated RF Emission
 Fast transient burst (2kV)
 Electrostatic Discharge (±15kV): IEC 61000-4-2
 Surge Immunity Test ( ±4kV)

FIRST TIME INSTALLATION

Infrastructure mode:
Infrastructure mode is one of the two methods of connecting the module to existing WiFi network
present at home or office with Wi-Fi enabled devices such as laptops, Smart phones etc. These
devices are connected to wireless network with the help of Access point (AP).
Setting Up Infrastructure Mode:
Power ON the meter and module. Configure WiFi router (or any smart device that support WiFi
hotspot) with SSID as "MiEnergyWiFi" and security as "Open". WiFi module joins with the
configured router and can be accessed for installation.
Note the IP address (For eg: '192.168.0.103') that will be displayed on DIN meter. Navigate to the
home page of the module using web browser by using the IP address as URL. Enter into
configuration page by clicking the link available in the home page using username "admin" and
password "lnt". Select mode of communication as "Infrastructure" in configuration page and also
assign desired SSID to the module. Various types of security such as Open, WEP64, WEP128, WPA,
and WPA2 are supported. Select the desired security settings. Save these details and module will
restart with new settings.
: IEC 61000-4-3
: IEC 61000-4-6
: CISPR 22
: CISPR-22-A
: IEC 61000-4-4
: IEC 61000-4-5
Page 4 of 8