Connection Diagram - L&T Electrical & Automation 1 Phase DIN Rail Meter User Manual

CONNECTION DIAGRAM

R-Phase
Y-Phase
3 Phase
B-Phase
supply
Neutral
OPERATING INSTRUCTIONS
Parameter scrolling:
Manual Scroll: Press and release the push button to view the next parameter. Meter will continue to be
in Manual scroll mode once push button is pressed and will change over to Auto scroll
mode if the Push button is left inactive for 5 minutes.
Auto Scroll : In Auto scroll mode, each parameter will be displayed for 6 seconds.
Push to push consumption: The push button is also used for measuring Push to Push kWh consumption.
Follow the below steps to measure the Push to Push consumption:
a) Scroll through the parameters until the push to push consumption (P0) is displayed.
b) When P0 is displayed press and hold the push button, it resets to zero.
c) Energy recording starts in P0 display.
d) To stop the Push to Push consumption press and hold the push button in P0 display.
e) Check the display parameter P1 to get the energy consumed value between the start and stop
operations.
M1 M2 M3 M0
L1 L2 L3
LOAD
Page 3 of 8