Configuring Communication - L&T Electrical & Automation 1 Phase DIN Rail Meter User Manual

Previous month consumption
22
(kWh)
23 First byte of IP address *
24 Second byte of IP address *
25 Third byte of IP address *
26 Fourth byte of IP address *
27
Slave ID **
28
Baud rate **
29 Parity **
30 Config
Indicates change over from
31 manual scroll mode to auto
scroll mode
32 Indicates data collection
* Parameters available only in WiFi mode of Communication.
** Parameters available only in MODBUS mode of Communication

CONFIGURING COMMUNICATION

Following settings need to be done to configure the DIN meter to WiFi or MODBUS mode:
 Connect the meter to the power supply and manually scroll till parameter "Config" is displayed.
 Press and hold the push button for 6 sec, meter will display "Yi-Fi", "ndbus","IEC"and "ESC"on
each scroll.
 Press and hold the push button for 6 sec after the required mode of communication. Select "Yi-Fi"
for Wi-Fi mode to use with Wi-Fi module and "ndbus" for MODBUS mode to use with RS-485
module.
 Meter will restart in selected mode of communication.
 After entering into Config menu, if the key is not pressed for 1 min then meter will resume to
Config display mode.
 After entering into Config Menu, if key is not pressed for 5 min then meter will resume to auto
scroll mode.
Page 6 of 8