Guidance And Manufacturer's Declaration - Electromagnetic Emission - Contec ESA0008 User Manual

CONTEC MEDICAL SYSTEMS CO.,LTD
Guidance and manufacturer's declaration – electromagnetic emissions-for
Guidance and manufacturer's declaration – electromagnetic emission
The
pulse oximeter probe
customer of the user of the
Emission test
RF emissions
CISPR 11
RF emission
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/ flicker
emissions
IEC 61000-3-3
Guidance and manufacture's declaration – electromagnetic immunity –
Guidance and manufacture's declaration – electromagnetic immunity
The pulse oximeter probe is intended for use in the electromagnetic environment specified below. The customer or the user
of pulse oximeter probe should assure that it is used in such an environment.
Immunity test
Electrostatic
discharge (ESD)
IEC 61000-4-2
Power frequency
(50/60Hz) magnetic
field
IEC61000-4-8
pulse oximeter probe
is intended for use in the electromagnetic environment specified below. The
pulse oximeter probe
Compliance
Group 1
Class B
Not Applicable
Not Applicable
for pulse oximeter probe
IEC 60601 test level
±6 kV contact
±8 kV air
3A/m
should assure that it is used in such and environment.
Electromagnetic environment – guidance
The pulse oximeter probe uses RF energy only for its internal
function. Therefore, its RF emissions are very low and are
not likely to cause any interference in nearby electronic
equipment.
The pulse oximeter probe is suitable for use in all
establishments, including domestic establishments and
those directly connected to the public low-voltage power
supply network that supplies buildings used for domestic
purposes.
Compliance level
±6 kV contact
±8 kV air
3A/m
Electromagnetic
environment - guidance
Floors should be wood, concrete or
ceramic tile. If floor are covered with
synthetic material, the
humidity should be at least 30%.
Power frequency magnetic fields
Should be at levels characteristic of
a typical location in a typical
commercial or hospital environment.
relative
4