Table of Contents
Advertisement
2. Secure the pipes by tightening the screw clockwise.
3. Align the slots on the lower blowpipe with the tabs on the upper blowpipe.
4. Slide the lower blowpipe over the upper blowpipe.
5. Rotate the lower blowpipe clockwise until a click indicates that the lower blowpipe is snapped and
secured onto the upper blowpipe.
6. To dismantle the pipes, turn the screw counter-clockwise (do not remove the screw nuts); loosen
the pipes and remove them.
Note: The lower and upper blower tubes are correctly installed when the arrows on both tubes are ex-
actly aligned.
Assembling the high-speed air nozzle
Attach the high speed air nozzle if higher airflow speed is desired.
1. Align the slots on the nozzle with the tabs on the lower blowpipe.
2. Slide the nozzle onto the lower blowpipe.
3. Turn the nozzle to the right until it clicks firmly into place on the lower blowpipe.
4. Each section of the pipe was then secured with a screw.
© by WilTec Wildanger Technik GmbH
Article 61955
Page 9
http://www.WilTec.de
http://www.aoyue.eu
12
2020-1
http://www.teichtip.de
Advertisement
Table of Contents
