Table of Contents
Advertisement
Before starting
Warning: Before you start work, please read the safety instructions for handling fuel. If you do not un -
derstand the safety information, you should not refuel your device. Contact a specialist.
Refuel the device
Carefully remove the fuel filler cap to add fuel. This engine is approved for operation with unleaded pe -
trol. Before operation, gasoline must be mixed with a high quality air-cooled 2-cycle engine oil. We re -
commend two-stroke oil mixed in a ratio of 1:40. When mixing fuel, follow the directions on the contai-
ner. Always read and follow the safety precautions before refueling your device.
Important: Alcohol-based fuels (gasohol or mixtures of ethanol or methanol) can attract moisture. This
breaks down the fuel mixture and acids can form during storage. Acidic gases can damage the engi-
ne's fuel system during storage. To avoid device problems, empty the tank if you are not going to use
the device for more than 30 days. Empty the fuel tank, start the engine, and run it until the fuel lines
and carburetor are empty. Use new fuel the next time you use it. Never add engine or carburetor clea -
ners to the fuel tank. Your device could be permanently damaged. Alternatively, fuel stabilizers can be
used during storage to reduce rubber build-up.
Stop the device
Release the throttle.
Press the stop switch to the stop position until the engine stops.
Before you start the engine
Warning: Before starting the device, make sure that the pipes are properly fastened.
Refuel the device. Stand at least 3 meters from the refueling point.
Hold the device in the starting position as shown. Hold the device so that the blower / sucti-
on pipe is not pointed at people, animals, glass or other solid objects.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Article 61955
Page 14
12
2020-1
Advertisement
Table of Contents
