WilTec 61955 Operation Manual page 10

Assembly of the collection bag
1. Unzip the collection bag and insert the connecting pipe.
2. Push the narrow end of the connecting tube through the small opening in the collection bag.
Note: Make sure that the edge of the narrow opening is flush with the widening connecting tube and
that the notch on the connecting tube points downwards.
3. Close the zipper on the collection bag. The zipper must be completely closed.
4. Remove the blower tube from the device.
5. Push the connecting pipe into the fan outlet. Make sure that the notch in the connecting pipe is on
the same line as the guide for the fan outlet.6. Turn the knob clockwise to secure the tube.
Assembly of the suction pipe
Warning: Stop the engine and ensure that the blower fan blades have stopped rotating before ope-
ning the suction port cover or removing the suction tubes or blower tube. The rotating blades can cau -
se serious injury.
1. Open the suction opening with a screwdriver. Keep the suction port lid open until the suction tube is
installed.
2. Slide the lower suction tube into the upper suction tube until the lower tube is firmly seated in the
upper tube.
© by WilTec Wildanger Technik GmbH Article 61955 Page 10
http://www.WilTec.de
http://www.aoyue.eu 12 2020-1
http://www.teichtip.de