Table of Contents
Advertisement
Cleaning the air filter:
A dirty air filter will affect engine performance and increase fuel consumption and emissions. Clean the
air filter after every 5 hours of operation.
1. Clean the cover and the areas around it to prevent debris from entering the carburetor when you
remove the cover.
Note: Before opening the air filter cover, move the choke lever to the "RUN" position.
2. Remove the parts as shown
Note: Do not clean the filter with gasoline or other flammable solvents. This can create a fire hazard or
harmful evaporative emissions.
3. Clean the filter with soap and water.
4. Let the filter dry.
5. Apply a few drops of oil to the filter; squeeze the filter to distribute the oil.
6. Reinstall the parts.
Replacement of spark plugs
Replace the spark plugs annually for easier engine starting and efficient operation. Set the electrode
gap to 0.0635 cm (0.025 in.). The ignition timing is fixed, i.e. it cannot be changed.
1. Turn, then pull out the spark plug boot.
2. Remove the spark plug from the cylinder and discard it.
3. Replace the spark plug with an RCJ-6Y type spark plug. Fasten it with a 19 mm socket wrench.
4. Reinstall the spark plug boot.
© by WilTec Wildanger Technik GmbH
Article 61955
Page 17
http://www.WilTec.de
http://www.aoyue.eu
12
2020-1
http://www.teichtip.de
Advertisement
Table of Contents
