Starting A Flooded Engine; Maintenance - WilTec 61955 Operation Manual

Start a warm engine
1. Press and hold the throttle lever.
2. Pull firmly on the starter handle while squeezing the throttle lever until the engine starts and runs
Note: Normally, the warm start can be carried out approx. 5 - 10 minutes after the device has been
switched off. After a downtime of more than 10 minutes, start the device after
cold start procedure or follow the start instructions printed on the unit.

Starting a flooded engine

Engines can be started by moving the start lever to the RUN position and pressing the throttle fully.
Pull the starter lever repeatedly while depressing the throttle until the engine starts and runs. This may
require pulling the starter handle several times, depending on how heavily the device is flooded. If the
device still does not start, refer to the troubleshooting section.

Maintenance

Warning!
Never touch the exhaust system unless the engine and exhaust are cold. Touching a hot

exhaust can result in serious burns.
The spark plug must be removed before maintenance work. This is not necessary for car-

buretor adjustments.
Check for loose fastenings and parts:
Exhaust

Spark plug gasket

Air filter

Housing screws

Check for damaged or worn parts:
Contact an authorized service dealer for replacement of damaged and / or worn parts.
Fuel tank → Never operate the device with a damaged or leaking fuel tank

Collection bag → Never operate the device with a damaged or torn collection bag.

Check and clean the device and labels
Check the device for loose or damaged parts after each use. Clean the device and the

badges with a damp cloth and mild detergent.
Dry the device with a clean, dry cloth.

© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Article 61955 Page 16
12 2020-1