Table of Contents
Advertisement
Conversion from leaf vacuum to leaf blower
1. Loosen the connecting pipe by turning the knob to the left and remove the connecting pipe and the
collection bag.
2. Turn the suction tubes clockwise and pull them off.
3. Close the lid of the suction opening; make sure the lid is locked into the tab.
4. Assemble the blowpipes again (see section "Assembling the blower pipe").
Adjustment of the shoulder strap
1. When vacuuming or blowing, always hold the device so that the exhaust pipe is kept away from
your body and clothing.
2. Place the shoulder strap over your head on your right shoulder.
3. Grasp the back of the collection bag with your left arm.
4. Adjust the shoulder strap so that the bag / shoulder strap seam lies between the thumb and forefin-
ger.
5. Make sure the shoulder strap is adjusted to allow unobstructed airflow out of the connecting tube. If
the collection bag is bent, the device will not work properly.
Operation
Operating position
© by WilTec Wildanger Technik GmbH
Article 61955
Page 12
http://www.WilTec.de
http://www.aoyue.eu
12
2020-1
http://www.teichtip.de
Advertisement
Table of Contents
