Advertisement
Step 6: Control Standoff Assembly
Insert (8) 4-40 x 5/8" Black oxide screws from the underside of the Base, and fasten to the two sets of
(4) of standoffs, as shown in Figure 6a. The ½" long standoffs are for the Eddie Control Board, and the
1.5" standoffs are for the Wiring Harness / Switch Plate assembly.
Figure 6a
Place (but do not attach) the Wiring Harness / Switch Plate assembly onto the Base as shown in Figure
6b. Carefully thread the Red and Black wires through the hole that's between the set of short standoffs.
Double-check to make certain that the Power Switches are both "off" as shown in Figure 6b.
Figure 6b
Copyright © Parallax Inc.
Eddie Robot Platform (28990 & 28992)
v1.1 1/16/2013 Page 9 of 17
Advertisement
