Advertisement
Step 7: Battery Shelf Installation
Flip the Base over, place the two Sealed Lead Acid batteries on the bottom of the Base, and connect the
Red and Black wires to the corresponding colored terminals, as shown in Figure 7a.
Figure 7a
Refer to Figure 7b. Carefully rotate the batteries, and gently place them between the two drive motor
assemblies. This should be a nice, tight fit. Be careful to not short the terminals of the batteries against
the frames of the motor assemblies. See Figure 7b.
Figure 7b
Copyright © Parallax Inc.
Eddie Robot Platform (28990 & 28992)
v1.1 1/16/2013 Page 10 of 17
Advertisement
