Extreme Networks ExtremeWireless AP460C Installation Manual page 18

Install the Access Point on a Vertical Pole or a
Horizontal Pole
•
A flat-head slotted screwdriver to tighten the clamp screws
About This Task
Install the access point on a vertical pole or a horizontal pole at outdoor environments. If you are resting
the access point under a horizontal pole, use this installation method only during indoor warehouse or
distribution center installations.
Caution
Do not install the access point in freezers.
Procedure
1. Thread the cable clamp straps through the access point rear slots.
2. Position and insert the cable clamp straps around the pole.
18 ExtremeWireless™ AP460C, AP460S6C, and AP460S12C Access Points
Important
You must provide your own cable clamps if you are mounting the access point to a pole
that is less than 3 in. or more than 7 in. in diameter.
Tip
The best practice is to use a stainless-steel cable clamp that is 0.5 in. (12.7 mm) wide.
Note
Ensure that the access point top slots face the sky and the bottom slots face the ground.
Install the Access Point