Extreme Networks AP305C Accessories Manual page 24

Install the Access Point on a Junction Box Using ACC-
BKT-AX-JB Accessory
Figure 8: Junction box accessory assembly
Callout
1
2
3
7. Align the red dot on the back of the access point against the red dot on the plastic part.
8. Push the access point onto the plastic part and turn it clockwise until you hear it lock in place.
9. Insert the RJ45 cable connector to the Ethernet connector on the access point.
10. When using a AP305C/CX or AP410C access point, attach the Ethernet port cap to the access point
Ethernet port.
For more information about Ethernet cap, refer to
11. Place the cable cover over the Ethernet cable.
24 Wi-Fi 6 (802.11ax) Access Points
Note
There is a metal pull ring in the metal part that is used to unlock and remove the plastic
part.
To unlock the plastic part, pull out the pin's ring and turn the plastic part 1/3
counter-clockwise and lift it apart.
Indoor Mounting Accessory Installation
Description
Sheet-metal junction box hole metal part
Plastic twist plate part
Pull ring with 10 mm diameter ring for unlocking the plastic
part
Ethernet Cap Accessory Information
rd
turn
on page 13.