Table of Contents
Advertisement
Trim Kit Installation
Install the valves: Starck only
Remove the valve mounting nuts from the valves.
Push the valves up into the mounting surface.
Install the mounting plates.
Tighten the tensioning screws.
Install the valves: all other styles
Remove the plaster shields, mounting plates, and stop rings
from the valves.
Push the valve up through the mounting surface.
Slide the stop ring onto the valve.
Install the mounting plate. The stop ring will stop it at the
proper height.
Rest the mounting plate on the mounting surface. Tighten the
mounting nut. Tighten the tensioning screws.
All models:
Connect the connecting hoses to the valve outlets.
Hold the hose steady with one wrench
while tightening the hose nut with a
second wrench.
Do not allow the hose to twist.
Install the hot and cold supply lines (not included).
8
Advertisement
Table of Contents
