Manufacturer's Warranty - Hilti DD 30-W Manual

Malfunction
Water escapes from the
chuck during operation.
8.2 The diamond core drilling machine is not in working order
Malfunction
The service indicator shows
nothing.
The service indicator lights.
The service indicator blinks.
9 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
9.1 Disposal of drilling slurry
Disposal of drilling slurry directly into rivers, lakes or the sewerage system without suitable pretreatment
presents environmental problems.
▶ Ask the local public authorities for information about current regulations.
▶ Dispose of the drilling slurry. → page 18
10

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
*2048398*
Printed: 05.07.2019 | Doc-Nr: PUB / 5283523 / 000 / 06
Possible cause
The chuck seal is defective.
Possible cause
The PRCD isn't switched on.
Interruption in the electric supply.
Water in the motor.
The carbon brushes are worn out.
The motor has overheated (e.g.
due to excessive lateral core bit
friction and/or excessive contact
pressure).
2048398
Action to be taken
▶ Check the seal and replace it if
necessary.
Action to be taken
▶ Check that the PRCD is
functioning and switch it on.
▶ Plug in another electric tool or
appliance and check whether it
works.
▶ Check the plug connections,
supply cord, power supply line
and main supply fuse.
▶ Allow the diamond core drilling
machine to dry out completely
in a warm, dry place.
▶ Replace the carbon brushes.
→ page 19
▶ Wait a few minutes until the
motor has cooled down or
allow the diamond core drilling
machine to run under no load in
order to speed up the cooling
process.
▶ Switch the diamond core drilling
machine off and then on again.
▶ Guide the diamond core drilling
machine carefully, keeping
it straight and/or reduce the
contact pressure.
English 21