Network Adapter / Ethernet Problems - AVERATEC 6100A User Manual

Network Adapter / Ethernet Problems

The Ethernet adapter does not work -
n
Hardware > Device Manager]. Double-click on Network
Adapters and check if a Fast Ethernet NIC appears as one of
the adapters. If it does not exist, Windows has not detected a
Fast Ethernet NIC or the device driver has not been installed
properly. If there is a yellow mark or red-cross on the network
adapter, it may be a device or resource conflict. Replace or
update the device driver.
n
cable are good.
n
Check to see if other workstations connected to the same hub
or concentrator is working.
The Ethernet adapter does not appear to operate in the
100Mbps transmission mode -
n
operation.
n
requirements.
n
socket that supports 100Base-TX mode. The hub may have
both 100Base-TX and 100Base-T sockets.
76
Go to [Start > Settings > Control Panel > System >
Make sure the physical connections on both ends of the
The hub or concentrator may not be working properly.
Make sure the hub you are using supports 100Mbps
Make sure that your RJ-45 cable meets the 100Base-TX
Make sure the Ethernet cable is connected to the hub ?