Intertek 51014 Owner's Manual page 8

Braided Cable
Brace
Outlet Box
Support
Open Loop
Washer
Secondary
Spring
Washer
Secondary
Secondary
Support Screw
ASSEMBLY INSTRUCTIONS
SECONDARY HANGING SYSTEM
For installation in the United States: Building codes
in the U.S.A. do not require installation of a Secondary
Hanging System. If desired, the braided cable can be cut
7
and removed using wire cutters (sold separately). Skip to
Step 10.
For installation in Canada: In compliance with building
codes in Canada, installation of the Secondary Hanging
System is required.
7. Feed the loop of the braided cable, preassembled to the
motor assembly, up through the outlet box mounted in the
ceiling.
8. Install secondary support screw, secondary spring
washer, and support washer partly into the side of the
8
brace installed in the ceiling. Then lift the braided cable up
and over the ceiling brace and place the open loop of the
braided cable around the secondary support screw.
Support
Note: The ceiling support brace may not be accessible
Screw
from below. If not, it must be accessed from above.
Important: The braided cable must make a complete
circle around the support brace to secure the fan.
9. Tighten the secondary support screw securing the
9
braided cable.
8