Intertek 51014 Owner's Manual page 7

Downrod
Downrod Clip
Tab
Slot
Downrod
Mounting
Bracket
ASSEMBLY INSTRUCTIONS
Set Screw
5
Downrod Pin
Yoke
6
5. Insert the downrod into the yoke and reinstall the
downrod pin and downrod clip. Then retighten the two
set screws.
Note: With wiring extending out of the downrod,
measure 8 inches of lead wire and cut the excess wire with
wire cutters (not included). Then strip 1/2" of insulation
from the end of each wire.
WARNING: Do not cut braided cable.
6. Lift the downrod into the mounting bracket. Rotate
the downrod until the tab in the mounting bracket is
seated in the slot in the downrod ball.
WARNING: The fan and/or downrod should
not rotate in the mounting bracket, if installed
correctly. Failure to align the slot in the downrod ball
with the tab on the mounting bracket may result in fan
falling causing serious injury or death.
7