Intertek 51014 Owner's Manual page 6

Mounting Bracket Screw
Downrod
Downrod
Clip
Downrod
Pin
ASSEMBLY INSTRUCTIONS
1
2
Set Screw
3
Yoke
Braided
Cable
Canopy
Yoke Cover
4
Downrod
Yoke
1.Turn OFF the electrical power at the main fuse or circuit
breaker.
DANGER: Failure to disconnect the power supply prior to
installation may result in serious injury or death.
2. Remove the mounting bracket by removing the two
mounting bracket screws from the round holes in the
canopy. Then loosen the other two mounting bracket
screws from the J-slots. Retain the mounting bracket
screws for later. Install the mounting bracket to the outlet
box (not included) using the screws and washers provided
with the outlet box.
Warning: To reduce the risk of fire electric shock,
or personal injury, mount to the outlet box marked
"acceptable for fan support" and use the mounting screws
and washers provided with the outlet box.
3. Remove the downrod clip and downrod pin from the
downrod. Then, loosen but do not remove the two set
screws at the top of the yoke.
4. Feed the wires and braided cable coming from the yoke
through the yoke cover, canopy and downrod.
6