Intertek 51014 Owner's Manual page 10

Motor
Assembly
Bulb
Thumbscrew
Glass Bowl
Reverse
Switch
Pull Chain Extension
ASSEMBLY INSTRUCTIONS
Blade
14
Motor Screw
15
Light Kit
16
Light Kit
17
14. Attach a blade assembly to the underside of motor
assembly using previously removed motor screws.
Completely secure each blade assembly before moving to
the next.
15. Install the bulbs into the sockets of the light kit.
Important: Make sure to allow the bulbs to cool before
you replace them.
16. Loosen the three thumbscrews near the bottom of
the light kit. Lift the glass bowl into the light kit and re-
tighten the previously loosened thumbscrews to secure.
17. Attach pull chain extensions to the pull chains.
Note: When facing the reverse switch, the fan pull chain
is on the left and the light pull chain is on the right.
Turn ON the electrical power at the main fuse or circuit
breaker and the wall switch.
Installation is complete.
10