Advertisement
Repair Instruction Manual
DOC.SAFM.Q4.E Rev. 0
3
Reassembly procedure
IMPORTANT
Check before replacing that both plastic adjustment screws have two O-rings in the top and bottom groove.
1. Mount the new adjustment screws and press them down until they are flush with the body.
Figure 8
Mount the new adjustment screws
2. Adjust the orientation of the heads of setting screws of the feedback mechanism to match the direction of
new adjustment screws.
Figure 9
Adjust the orientation of the heads of setting screws
3. Place the feedback mechanism back into housing. The mechanism can be pressed down to the same level
of the machined surface if the rotation of the screw and plastic are matched in step 2.
4. Place the spring back and put the washer on, make sure the direction of washer is correct so that the E-clip
can sit in.
Figure 10
Place the feedback mechanism back
Press down to the same level
O-ring seals
Heads of setting screws
of the feedback
mechanism
Place the spring back and put the
washer on top
March 2018
9
Advertisement
