Advertisement
March 2018
WARNING - WEAR SAFETY GLASSES
!
Wear safety glasses when compressing the spring.
Release your fingers slowly after mounting the e-clip.
Try a different angle if you fail to compress the spring and washer.
5. Press the spring with spring washer down untill the groove and the switch operating rod is visible.
6. Use the e-clip tool to mount the e-clip in the groove.
Figure 11
Mount the E-clip
7. Place back the bushing and mount the cover back in place. Tighten the screws with 8.85 lbf.in (0.73 lbf.ft or
1 Nm) of torque.
IMPORTANT
Make sure that the bound seals are in place when mounting the cover screws.
Figure 12
Place back the bushing and mount the cover
10
Groove on switch operating rod.
Guide bushing
Repair Instruction Manual
Make sure that the bound seals
are in place when mounting the
cover screws
DOC.SAFM.Q4.E Rev. 0
Advertisement
