Modifying Virtual Ports - Avaya P550R User Manual

Modifying Virtual Ports

Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink Module User Guide, Version 2.0
Table 24. Virtual Port Configuration Parameters
Parameter
Traffic Shape Rate
(cps)
Path Cost
Add/Prefix Reg:
ILMI
Signaling Type
To modify virtual ports:
Definition
Enter the maximum cell rate allowed on
this virtual port. The range is 0-line rate
cps. The default rate is full bandwidth.
The traffic shape rate for all virtual ports
combined cannot exceed the total traffic
shape rate for that physical port.
This is based on the type of module:
• OC-3 - 353207
• OC-12 - 1412830
Note:
Traffic cannot flow if the Traffic
Shape Rate is 0.
Note:
When UBR connections are
established on a virtual port, the
Traffic Shape Rate (cps) is ignored
for UBR traffic flows.
Enter the PNNI link cost or Failover
weight of this interface. The range is
0-16777215.
Select the address and/or prefix
registration. Options include:
• Yes - Enabled
• No - Disabled
Note:
Address registration is required in
the UNI mode only.
ILMI is enabled and cannot be
modified.
Select which signaling service to use on
this port. Options include:
• Auto - Default
• PNNI 1.0 (if Multiport = YES)
• UNI 3.0 (if Multiport = NO)
• UNI 3.1 (if Multiport = NO)
• UNI 4.0 (if Multiport = NO)
• None (if using RFC1483 mode only)
Configuring LANE
3-7