Table of Contents
Advertisement
SpA
ATTENTION:
When you turn the steering column you hav e to turn the w heels as
well: the Right to the Left, the Left to the Right. Picture 9 shows the
correct position (see groove)
Befor e starti ng the machine always control :
!
the oil levels in the engine with the proper oil dips tick and in the gear box by means of the s uitable screw ( make this onl y when the
mac hine is new and every 50 hours );
!
that in the air-filter (if in oil bath) oil reac hes the reference notch;
!
that tyres have the right press ure ( Atm. 1,3) and are c orrectly oriented (see Picture 9 );
!
that all screws and nuts are well fas tened;
!
that all levers are in neutral position;
!
that the clutc h lever has some freeplay;
!
that there is fuel in the tank, the refuelling must be done with a funnel c omplete of filter i n order to avoi d the introduction of impurity;
!
Before starting the m achin e m ake sur e there ar e not walls or obstacles behind you .
To start the machine pro ceed in the follo wing way:
1) Engage the clutch, (Ref. "A" Picture 5), lower the ENGINE STOP lever, (Ref. "B" Picture 5) and loc k both with the rectangular pus hbutton
inside the l eft handle, (Ref. "A" Picture 6) (ENGINE STOP devic e).
2) Close the air to the carburettor (starter), open the fuel coc k, positi on the acc elerator hand lever, (Ref. "C" Picture 5), at ½ gas and pull
vigorousl y the rope of the ignition, (Ref."15" picture 1). When the engine is running release the starter.
3) Warm up the engine for some minutes befor e starti ng to wor k.
When the engine is new, m ake som e running in p eriod.
Accurately inspect the wor k area, removing foreign objects ( iron wires, stones, stic ks, glasses etc.), sinc e they c oul d cause dangerous and
sudden r eactions of the machine.
Engage the clutch, the ENGINE ST OP pushbutton will release its elf, then put into gear and power take-off, giving little clutc h-touc hes if it
does not i mmediatel y engage.
Accelerate opportunel y the engine and rel ease the clutc h to start wor king.
ATTENTION If the power take-off is engaged, you cannot engage the rev erse gear. In this case disengage the power
take-off and then engage the rev erse gear. It is impossible to insert the milling cutter when the reverse gear is engaged.
Once you have ended your wor k, to stop the engine cl ose the fuel c oc k and push the STOP ENGINE button or release the ENGINE STOP
lever. (Ref. "B" Picture 5).
15 USE OF THE MACHINE – MILLING UNIT REVERSIBILITY
The princi pal us es of the mac hine are:
Cultivator version (See Picture 2);
Power mower version (See Picture 2a).
12 MACHINE STARTING
BEFORE USING THE MACHINE MAKE SURE YOU LEARNT HOW TO STOP
IT; IN CASE OF BREAKDOWN OR NECESSITY TAKE IMMEDIATELY THE
LEFT HAND AWAY FROM THE HANDLE (ENGINE STOP).
13 – START OF THE WORK
14 – END OF THE WORK
MC 2300
Picture 9
7
Hide quick links:
Advertisement
Table of Contents
