Security Terms; Starting And Stopping The Machine - Benassi BL 300 Use And Maintenance

S.p.A.
WARNING:
Please read very carefully this booklet before using your cultivator; Carefully using and servicing this machine,
you will certainly get satisfactory performances for a long time.. FAILURE TO COMPLY WITH THESE
INSTRUCTIONS MAY RESULT INSIDIOUS OR EVEN FATAL INJURY.
•
The use of the machine is forbidden to persons younger than 16 years.
•
The operator is responsible of any possible damage and he should always drive the machine carefully and safety.
•
Before carrying the machine always empty the fuel tank.
•
Before leaving the machine be sure that it is fully stopped.
•
Never use the machine without heavy shoes and long transfers. Always inspect the area where you want to work taking off stones,
branches, cables and any other thing which can be dangerous.
•
Before start working, make sure that a radius of minimum 5 mt. is completely free.
•
Clean any possible leakage of fuel.
•
Fill up when the engine is off and not hot, always in an open space far from fires or any heating source and refrain from smoking
during this operation.
•
Before starting the machine make sure that you can quickly stop the engine and that you are familiar with the control levers.
•
Never allow the engine to run in enclosed spaces where the highly toxic carbon monoxide could not evacuate.
•
Never start or use the machine not completely assembled especially concerning the safety devices and the tiller protection guards
which should always be completely assembled with all its extensions.
•
Never fix or clean the tiller blades or any other tools when the engine is running.
•
Attention ! Don't' use the machine on sloping grounds exceeding the 30%
• We are not responsible for accidents due to the wrong use of the machine neglecting the above basic instructions.

STARTING AND STOPPING THE MACHINE

Starting the engine of the machine always follow these instructions very carefully:
•
Check the oil in the engine : THE BRAND NEW MACHINE IS DELIVERED WITHOUT OIL IN THE ENGINE, THEREFORE YOU
SHOULD FILL IT UP TO THE LEVEL ON THE DIP STICK OF THE OIL CUP.
•
Please check the engine USE AND MAINTENANCE concerning the "operations before staring".
•
Start the engine only in open spaces.
1. Pull the choke lever on the engine.( where present is)
2. Turn the accelerator lever "F" to the "MAX" position (Pict. 8a and 8b). The switch (Ref. "K" Pict. 8b) must be "ON".
3. The clutch lever "G" should be released in position "a" (Pict. 9-10).
4. Pull the starting rope by the handle "I" smoothly first than strongly: when you feel some resistance don't leave the handle but
help the recoiling of the rope with your hand (Pict. 11).
5. When the engine runs move the choke lever to the initial position and the accelerator lever in the mid-position (Pict. 8a and 8b
Ref. "F").
6. For stopping the engine move the accelerator lever "F" in "STOP" position (Pict. 8a) and the switch (Ref. "K" Pict. 8b) must be
"OFF".
20

SECURITY TERMS

BL 300 / BL 350