Table of Contents
Advertisement
8.2 Adjusting the running wheels
6
If the machine only sands on one side, the surface setting must be adjusted. Following
replacement of the sanding drum or running wheels, the surface setting must always be newly
adjusted. To make a level, uniform setting, the sanding drum and the running wheels must rest
D
on the same plane. The right running wheel is adjustable. The left wheel does not adjust.
The running wheel adjustment gauge is required to adjust the machine.
For optimal results check the the grinding pattern after adjusting.
Instructions:
1. Turn the machine off.
2. Disconnect the machine from the mains power.
3. Lay the machine on its left side.
C
B
4. Use the roller adjuster to adjust the
the ACTUAL position of the adjustable roller.
5. Check the grinding pattern. If the machine grinds more on the roller protection side (1), the adjustable wheel must
be adjusted away from the machine base. If the machine grinds more on the belt guard side (2), the adjustable
wheel must be adjusted in the opposite direction to the machine base.
A
6
6
5
D
6. Set the wheel adjustment aid to the desired nominal dimension.
C
B
PALLMANN GmbH l Ein Unternehmen der Uzin Utz AG | Im Kreuz 6 | 97076 Würzburg | Telefon +49 931 27964-0 | Telefax +49 931 27964-50 I www.pallmann.net
5
5
4
3
26
WOLFF Eine Marke der Uzin Utz Gruppe
4
3
WOLFF Eine Marke der Uzin Utz Gruppe
Änderungen
Zust.
4
3
2
1
D
Correction for grinding pattern (1)
C
Actual state
Correction for micrograph (2)
B
1 : 2
Mat-Nr.
Oberfläche
Maßstab
Werkstoff:
2
Oberfläche
M
Z
Datum
Name
Bearb.
01.10.2014 HeinzD
Gepr.
Fr
Norm.
370001001-0_5.idw
Datum Name
Dateiname
2
Advertisement
Table of Contents
