Connecting The Cobra Classic To The Mains Power - Pallmann COBRA CLASSIC Translation Of The Original Operating Instructions

7.8 Connecting the COBRA CLASSIC to the mains power
Instructions for connecting to mains power:
1. Make sure that the switch (1) is in the off position. The machine must be switched off before
connecting up to the mains power.
2. The main lifting lever for the sanding drum (2) must be moved backward so that the sanding
drum is raised from the fl oor.
3. Hang the swivelling cable arm (3) into the left or right cable arm bracket as required.
Wind the mains cable through the curl at the end of the cable arm (3) to keep the cable
away from the sanding zone.
4. Connect the coupling (4) of the mains cable to the motor plug, which must be disconnected
from mains power.
5. Connect the plug of the mains cable via a portable RCD (Residual Current Protective
Device) to an adequately fused and earthed 230 V mains socket.
Caution! Never switch the motor on if the sanding belt is not tightened.
Caution! Never switch the motor on if the sanding drum is not raised from the fl oor.
Caution! Risk of injuries from the machine starting up unintentionally! Disconnect the machine from
the power supply when not in use, when changing the sanding belt and when
PALLMANN GmbH l Ein Unternehmen der Uzin Utz AG | Im Kreuz 6 | 97076 Würzburg | Telefon +49 931 27964-0 | Telefax +49 931 27964-50 I www.pallmann.net
7.9 Anmerkungen zum Schleifen von Parkett- und Dielenfußböden
15