Ihse 474-SNMP User Manual page 44

Configuration via Management Software
The following parameters are pre-configured or can be configured:
SNMP Agent
Field
SNMP Agent
SNMPv3
Port
Configured SNMPv3
User
SNMP Trap
The SNMP agent must be activated to activate the SNMP traps.
Field
Enable Traps
SNMP Server
Port
If you activate the checkbox Enable Traps, the following traps are activated by default:
Field
Temperature
Enabled Slot
Disabled Slot
Invalid Slot
Link Status
Power Supply
44
Entry Description
Activated (not Permission for an active query of the SNMP agent for traps is
deactivate- granted. This activation is a prerequisite for using the SNMP
able) server.
Activated The encrypted SNMP monitoring (SNMPv3) is activated
(default).
Deactivated The unencrypted SNMP monitoring (SNMPv2) is active
(default).
Numerical The SNMP port is called up automatically (default: 161).
Text Name of the SNMPv3 user (default: draco)
Changing the username, see chapter 5.5, page 50
Entry Description
Activated Activates the active sending of trap messages from the SNMP
agent to the SNMP server
Deactivated No traps are sent to the den SNMP server (default).
Byte Input of the IP address of the SNMP server in the form
"192.168.1.1"
Numerical Input of the SNMP port (default: 162)
Description
Notification of the temperature of the power supply units
Notification about an extender newly inserted to the chassis
•
Notification about a switched-on extender
•
Notification of an extender removed from the chassis
•
Notification of a switched-off extender
•
The inserted extender cannot be recognized
Notification of the connection status between two extenders or an extender and
a matrix with numerical output:
• 0: link not available
• 1: link 1 is available
2: link 2 is available (with redundant extenders)
•
-1: The extender used cannot output any link information
•
Notification of the status of the power supply units
SNMP Module