Table of Contents
Advertisement
SNMP Module
5
Configuration via Management Software
Possible loss of changes
By clicking the Apply button changes are applied to the active configuration and saved in the volatile
memory of the SNMP module. In the event of a sudden power failure, these changes are lost. To save
changes permanently:
save the configuration changes into the active configuration (Remote Save,(see chapter 5.7.1,
page 62)) or perform a restart (see chapter 6.9.2, page 92).
A change in system-relevant parameters (e.g. change of the IP address) is immediately displayed in the
management software. To initialize system-relevant configuration changes on the SNMP module, the
SNMP module must be restarted. The restart of the SNMP module may take several minutes, and the
SNMP module is not available during the restart.
5.1
Configuring in Online Mode
Configurations and system settings can be edited via management software in online mode with an active
connection between SNMP module and management software. Hereby, the following steps are necessary:
1. Connect the management software with the SNMP module.
When connecting the first time, the manufacturer-specific configuration (Factory Settings) saved on the
SNMP module) is loaded into the management software.
2. Click the Activate Edit Mode menu item in the toolbar.
The edit mode is active. A symbol is shown in the status bar.
3. Make any edits in the configuration and system settings.
4. Click the Apply button to confirm the changes.
The changes are applied immediately as the current configuration running in the volatile memory of the
SNMP module.
5. Click the Deactivate Edit Mode menu item in the toolbar.
6. Click the Remote Save button to save the configuration to the SNMP module.
7. Optionally: restart the system (depending on the settings made).
Configuration via Management Software
NOTICE
NOTICE
31
Advertisement
Chapters
Table of Contents
