Toto Washlet TCF4911E Series Instruction Manual page 65

Trouble
The toilet seat is
cold
Trouble
The Energy saver LED
does not light up
The timer energy
saver feature is not
working
The auto energy
saver+ or auto
energy saver feature
is not working
Toilet Seat and Toilet Lid
Please check
● Is the toilet seat temperature set to "OFF" or a low level?
● Is energy saver in operation?
The energy saver feature is on when the "Energy saver" LED is on and the
"Power" LED is off on the main display.
When you sit on the seat, the toilet seat heater is turned on temporarily and
the seat is warmed in about 15 minutes.
➞ You can turn it "OFF" if the energy saver feature is "ON".
● Have you been seated for a long time?
After about 20 minutes of sitting, the temperature starts going down, and
after about 1 hour, the toilet seat heater is turned "OFF".
➞ Stand up from the seat and then use again.
● The seat switch will not turn on unless you sit on the seat properly.
➞ Sit back on the toilet seat.
● Is a toilet lid or seat cover installed?
➞Remove any covers.
Energy Saver
Please check
● Did you switch the breaker on the distribution board to off or was there a
power outage?
The "Energy saver" LED on the main display may go off when the power is
turned on even if the energy saver feature is "ON".
(It will turn on within about 24 hours since the setting is retained.)
● Did you replace the remote control batteries?
"Timer energy saver" may be canceled when the batteries are replaced.
➞ Set the timer energy saver again at the time you want to start it.
● Because the function takes several days learning the usage conditions before
starting energy saver, the amount of energy saving may be low, depending
on the frequency of use.
➞Check the energy saver setting.
Ref.
Page
24
26
28
-
9
9
Ref.
Page
-
28
26
65