Advertisement
If the parking lights flashed three times, then the alarm was triggered in your
absence. Before turning the key on, examine the L.E.D. to identify which zone
was triggered.
Siren / Horn does not sound.
If the siren and or horn sounds 4 chirps, then the alarm was triggered in your
absence. Before turning the key on, examine the L.E.D. and refer to the
INTRUSION WARNING SIGNALS section of this manual to identify which
zone was triggered.
Doors Unlock.
Using the optional ACCESS GUARD feature, the alarm can be wired to unlock
only the driver's door during this step. To unlock all doors, press and release
the Lock/"Arm" / Unlock/"Disarm" button a second time within 5 seconds.
Courtesy lights turn on for 30 seconds, or until the ignition key is switched on.
INTRUSION WARNING SIGNALS
This system will inform you if an intrusion attempt has occurred while you were away from
the vehicle. If an intrusion attempt has occurred, the siren/horn will chirp 4 times and the
parking lights will flash 3 times when disarming the system. Enter the vehicle, and observe
the red dash mounted L.E.D. to identify which zone was triggered.
If the L.E.D. is flashing one time...pause...one time...pause...etc., then an intru-
sion attempt was made to the optional shock sensor, or an accessory triggering
device that may have been added to the system.
If the L.E.D. is flashing two times...pause...two times...pause...etc., then an in-
trusion attempt was made to a hood or trunk pin switch that was added to the
system, or to a light activated entry point if the alarm was installed using the
voltage sensing feature.
If the L.E.D. is flashing three times...pause...three times...pause...etc., then an
intrusion attempt was made through one of the vehicle's doors.
These intrusion warning indicators are stored in the system's memory, and will only be erased
when the ignition key is turned on.
VALET / SYSTEM OVERRIDE SWITCH
The valet switch allows you to temporarily bypass all alarm functions, eliminating the need to
hand your transmitter to parking attendants or garage mechanics. When the system is in
valet mode, all alarm functions are bypassed, however the remote panic feature and remote
door locks will remain operational. To use the valet mode;
1. Enter the vehicle, and turn the ignition key to the on position.
2. Move the valet toggle switch to the on position. The dash mounted L.E.D. will
turn on solid, and remain on as long as the system is in valet mode.
3. To return to normal operation, move the valet switch back to the off position
any time the ignition is on.
In the event that you lose your keychain transmitter, or if the transmitter fails to disarm the
system, the valet switch can be used to disarm the alarm. Open the vehicle's door ( the
alarm will sound ). Turn the ignition key on, and move the valet switch to the on position. The
alarm will disarm, and the vehicle can now be started.
NOTE: Always remember to move the valet switch back to the off position. This will
ensure that the vehicle remains protected at all times.
Page 4
Advertisement
