Hunter Hydrawise PRO-C Software/App Owner's Manual page 12

Step 3: Unthread the existing antenna. Thread on the
included SMA Adapter (red cap) until hand tightened. Next,
thread on the extension cable (9') until hand tightened.
Attach included antenna to the other end of the cable.
Step 4: Route antenna cable through the channel at the
bottom of the facepack. Remember to re-install the plastic
cover over the compartment. Note: Drilling into the
cabinet is not recommended. Please only use existing
conduit knockouts.
Step 5: Route antenna cable from enclosure through ¾"
(20 mm) plastic electrical conduit. Use standard fittings to
position the antenna where required. Do not exceed
supplied cable length.
Step 6: Route cable and antenna through standard ¾" (20
mm) threaded adapter with male threaded end up.
Step 7: Insert the antenna into the open side of the lower
tube (fit the cable through the slot). Adjust holder length by
sliding upper body into the lower body.
Step 8: Drop the antenna holder into threaded conduit
fitting, and allow the holder rim to rest on top of the fitting.
Copyright 2021 Hunter Industries. All Rights Reserved. 12