KMART 42956952 Quick Start Manual page 5

Step 2: Install the Handlebar Post.
A. Connect the sensor wire together with the one from handlebar post (Part 4). Connect the
tension control cable together through the handlebar post (Part 4) as shown in below image.
Note: Rotating the tension adjustable knob can adjust the length of cable inside the
tube from the handlebar post.
B. Insert the handlebar post to the tube of the main section (Part 1), secure them with the screws
which pre-attached to the hole of main frame.
2-A
Step 3: Install the Connector.
Take out the connector (Part 5), unscrew the nuts, then insert it into the Handlebar post (Part 4).
2-B
4