John Lewis Asuka double bed 803/13901/02 Quick Start Manual page 3

Step by step assembly instructions
Step One
1. Push the 8 threads, E into the headboard and the footboard as shown below.
Tighten the threads by hand ensuring that there is approximately half of the threads still showing.
Using the 12 x 20mm screws, I attach the two brackets, J into the headboard and the footboard using the
pre-drilled holes, tighten with a phillips screwdriver.
2. Making sure the holes in the slat support rails,3, are facing upwards, locate the side rails onto the
protruding threads and dowels on the headboard and foot board.As you do this, slide a half moon washer, C
onto the thread when it comes through into the circular hole in the side of the rail, then add the washer, A,
the split washer, B and finally the nut, D in that order and then screw the nut
Repeat with the other three corners, then
FOUR CORNERS ARE SECURED
TIGHTEN FIRMLY WITH THE SPANNER PROVIDED, WHEN ALL
.
See below.
FINGER TIGHT ONLY.