Product Safety Information; Power Management System; Product Specifications; Installation And Lubrication - Ingersoll-Rand 232TGTi Series Product Information

Product Safety Information

Intended Use:
These Air Impact Wrenches are designed to remove and install threaded fasteners.
For additional information refer to Air Impact Wrenches Product Safety Information Manual Form
04580916.
Manuals can be downloaded from www.irtools.com.

Power Management System

For models that include a power management system, the system allows operator reduction of maximum
output power in either the forward or the reverse direction.
For reduced power in the forward direction and full power in the reverse direction, push the reverse
valve inward on the right side of the tool and rotate the reverse valve until the notch on the right side aligns
with the desired number on the right side. This provides reduced power in forward but full power in reverse
when the reverse valve is pushed in the opposite direction. (See TPD1248 on page 2.) For reduced power
in the reverse direction and full power in the forward direction, push the reverse valve inward on the left
side of the tool and rotate the reverse valve until the notch on the left side aligns with the desired number on
the left side. This provides full power in forward but reduced power in reverse when the reverse valve is
pushed the opposite direction. (See TPD1249 on page 2.) For full power in both directions, rotate the
Reverse Valve until the notch on each end of the Reverse Valve aligns with 5 on each side of the housing.
The power level indicators (See TPD1248 & TPD 1249 on page 2.) are for reference and DO NOT indicate a
specific power. The power output can be further reduced in forward or reverse by using the variable throttle.

Product Specifications

Model(s) Style
232TGTi Pistol
232TGTi-2 Pistol

Installation and Lubrication

Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain condensate from
valve(s) at low point(s) of piping, air filter and compressor tank daily. Install a properly sized Safety Air Fuse
upstream of hose and use an anti-whip device across any hose coupling without internal shut-off, to prevent
hose whipping if a hose fails or coupling disconnects. See drawing 04581666 and table on page 2.
Maintenance frequency is shown in circular arrow and defined as h=hours, d=days, and m=months. Items
identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
Form 04581609-Edition 2
Drive
Type
Square
Square Extended 1/2" x 2"
5. Hose diameter
6. Thread size
7. Coupling
8. Safety Air Fuse
Impacts per
min.
Size
1/2" 1,250
1,250
Recommended Torque Range
Forward Reverse
ft-lb (Nm) ft-lb (Nm)
40-400 50-500
(54-542) (68-677)
40-400 50-500
(54-542) (68-677)
9. Oil
10. Grease during assembly
11. Grease - through fitting
3